Posts

Showing posts from September, 2016

IOT Beginner| Blink LED program & Setup Arduino

Image
Hi Friends, In this article we would how to start with Arduino setup & a very basic program to Blink LED.  This article is for beginner who are IOT Enthusiastic.  Requirements: 1) Arduino board  2) 1 LED 3) Jumper wire   4) Resistor (200 OM) Diagram: Program:  void setup() {   // initialize digital pin 13 as an output.   pinMode(13, OUTPUT); } // the loop function runs over and over again forever void loop() {   digitalWrite(13, HIGH);   // turn the LED on (HIGH is the voltage level)   delay(1000);              // wait for a second   digitalWrite(13, LOW);    // turn the LED off by making the voltage LOW   delay(1000);              // wait for a second } Compile & upload program on your Arduino board. you should be able to see Blinking LED. Simulate here:   https://circuits.io/circuits/2655115-b...